MCDONOUGH PALLET RACK

Pallet Racks in Fayetteville, GA

The Lee Center on Bethea Road contains twelve warehouse buildings with spaces from 800 to 16,200 square feet, about nine miles south of Hartsfield-Jackson off GA-314. In this market, a right-sized storage block and an accessible door matter more than a warehouse-wide grid of long rows.

McDonough Pallet Rack serves Fayetteville about twenty-five miles from McDonough. We plan new selective rack, industrial shelving and small mezzanine possibilities around actual load sizes and work paths. A compact layout should make stocked items reachable without using the only turning area as reserve storage.

Typical local buildings are smaller M-1 warehouses with roughly 20–21 ft clear height and drive-in doors. Measure the actual occupied unit before choosing beam levels. Tall loaded pallets can consume a large share of the vertical room, while shorter boxed stock may allow a different spacing schedule. The forklift’s reach with the intended load still needs checking even where the building is comparatively low.

Beam span should suit the pallet family and supported weight. A contractor’s wide or irregular load may need a different bay from a wholesaler’s boxed pallet. Record overhang, tallest wrapping and heaviest routine loads rather than using a single average. Decking or supports should follow the selected storage arrangement and should not be treated as an increase in the specified beam capacity.

Kenwood Business Park on GA-85 is about seven miles from I-85, and East Fayette Industrial Park lies near Pavilion Parkway. The Lee Center’s small-unit stock creates another distinct layout setting. In any of these areas, the drawing should show the occupied suite, drive-in door and loaded truck’s turn into the working aisle. Row length should follow that access, not simply the length of the available wall.

For a small distributor, selective positions can hold different stock lines without assigning a deep lane to each item. Put fast-moving pallets where they can be replenished and dispatched without crossing the whole unit. Reserve locations should remain separate from inbound checks and temporary staging. A few additional rack bays offer little benefit if they eliminate the place needed to prepare an incoming load for storage.

Loose parts, case picks and contractor supplies may fit industrial shelving systems better than full-pallet rack positions. Compare the quantity kept for daily access with the quantity held in reserve. New selective rack can hold replenishment pallets while smaller storage handles individual items, allowing each type of stock to occupy a position suited to its handling method.

A small mezzanine can be considered when its stored items, replenishment and access fit the measured clear height. Discuss the intended use while locating rack rows and door approaches. In 20 ft space, the raised area and surrounding pallet heights need coordinating from the outset. Avoid planning a pallet grid first and assuming that a parts-storage level can later be inserted into whatever room remains.

Installation material can quickly occupy the usable working area in a Fayetteville small bay. Agree on a receiving door, staging footprint and row sequence before the work begins. Georgia summer heat affects crews in non-air-conditioned warehouse stock, and seasonal thunderstorms influence unloading coordination. Keep the stock-transfer path distinct from the rack-material area so inventory can reach completed positions without crossing unfinished work.

If moving into Bethea Road, Kenwood or East Fayette space, settle the destination plan before rack teardown at the old unit. Different door positions or a lower clear height may require shorter rows and new beam spacing. Send the suite dimensions, loaded pallet sizes, weights and handling equipment details to McDonough Pallet Rack. A warehouse consultation can define an itemized rack supply and installation scope that suits the contractor, wholesaler or small distributor actually using the Fayetteville space.

Storage systems for the working load

Compare pallet rack, pushback rack, pallet flow rack, drive-in rack, cantilever rack, carton flow rack by pallet access, stock rotation and the dimensions of the handled item. For a move into Fayetteville, our warehouse relocation service starts with the destination layout.

Fayetteville rack planning questions